T-1 3/4 (5mm) SOLID STATE LAMP L-1513SURC-E HYPER RED Description Features LOW POWER CONSUMPTION. The Hyper Red source color devices are made with DH VERSATILE MOUNTING ON P.C. BOARD OR PANEL. InGaAlP on GaAs substrate Light Emitting Diode. T-1 3/4 DIAMETER PACKAGE, TAPERED TYPE. RELIABLE AND RUGGED. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD0443 REV NO: V.3 DATE: MAR/22/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG PAGE: 1 OF 3 Selection Guide Part No. Dice L-1513SURC-E Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2 1/2 1500 2200 20 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Hyper Red D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 630 nm IF=20mA Spectral Line Half-width Hyper Red 25 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Hyper Red Units Power dissipation 150 mW DC Forward Current 30 mA Peak Forward Current [1] 200 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 3 Seconds Lead Solder Temperature [3] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAD0443 REV NO: V.3 DATE: MAR/22/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG PAGE: 2 OF 3 Hyper Red L-1513SURC-E Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD0443 REV NO: V.3 DATE: MAR/22/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG PAGE: 3 OF 3